Are you a proud owner of a Mazda6 and are you looking for ways to upgrade the radio in your car? Then you will find this article helpful because this article will show you the how to remove the radio from a mazda6. For upgrading the radio in any car, the first step is to remove the radio from that car. It is actually quite easy to remove the radio from a high end car like Mazda if you follow the steps exactly as it is provided here. This tutorial is applicable for the Mazda\’s manufactured from 2003 to 2008.

This is almost common for the above models and there are some tools that will come handy while doing this task. Pliers, wrench and a screwdriver all of appropriate sizes are some things that are needed.

The things you will be in need are pliers, screw driver and socket wrench. Make sure you have screw drivers of different sizes. If you do not have screw drivers of different size then you may be stuck in the middle. Make sure all these things are ready before starting your work to avoid unnecessary wastage of time.

For removing the gear shift knob rotate it in the counter clockwise direction. After a few rotations you will find the knob loosening; after loosening it remove the gear shift knob. Now remove the console from the car. You will find that the console extends to the ashtray. After removing the console you will find a couple of screws located in the underside of the climate control panel. Remove both the screws by rotating them in counter clockwise direction, with the help of a screw driver.

The glove compartment is opened to gain access to the side-mounted bold of the radio. The sides of this compartment are squeezed simultaneously, and are made to be dropped down. Once this is done, the screws that are seen can be removed.

The glove box is removed and the next moment the radio is made accessible. The sides of the glove box is squeezed and then dropped down. Now you will find a ten mm bolt on the left side. This bolt is removed carefully.

After removing the old radio, you can now install the new radio. The steps involved in the installation of the radio are exactly the reverse of the steps mentioned above. Replace the screws and the covers. Now put the gear back to its original position and connect the negative cable back to the negative terminal of the car\’s battery.

This article therefore throws light on all aspects of removing the battery and the radio. It is essential to remove the battery to prevent any case of short circuit in the car while working on this removal. Now you know how to remove the radio from Mazda 6.

Purchase at the best prices on Radiohalterung, then visit www.powernetshop.at to find the best advice on radio dash kits for you. Get a totally unique version of this article from our article submission service